Installation Guides
      Back to home
      1. CCS Knowledge Base
      2. PhotoMatch
      3. Installation Guides

      Programming Your Teemi T22N Scanner to Work with PhotoMatch

      The Teemi T22N scanner can be used with PhotoMatch. It must be programmed before it will work with PhotoMatch

      Teemi T22N 2D QR/Barcode Scanner    

      Buy on Amazon

      Programming the Teemi T22N scanner for use with PhotoMatch

      1. Plug the scanner into your tablet or computer
      2. Wait for your computer to recognize the scanner (a popup will say your new device is ready to use)
      3. Close or minimize all programs and browsers on your computer
      4. Scan each barcode code below, in the order they appear, one at a time, and wait for the beep(s) after each scan before scanning the next code. (printable version)












      10. BEFORE going to your next event. Open PhotoMatch and test the scanner in an event to confirm it has been properly programmed.   If you have any issues, repeat steps 1-9 and try again.

       

      If you need to reset and start over, you can scan the factory reset, then repeat the above steps.